IoT Applications with Impulse reading

  • Power, water, gas, heat or similar consumption readings
  • Analysis of consumption savings and dynamic advance billing.
  • Detection of media leakage or sharp consumption change (water, gas leakage).
  • Irregular (volume based), monthly or more frequent readings (15min-24h intervals)
  • Monitoring of load or overload of machines or equipment (with detection of short-term peaks)

SENSECOM-IMD (IMDS, IMDBS)

  • Primary input – S0 input
    • impulse reading from billing or secondary power-meter and other meter having S0 input
    • S0 – galvanically separated 4,5kV by powered optron
    • Supports 2-level tariffs (by grounding to neutral wire)
  • Secondary voltage-free input
    • reading from a gas meter / water meter equipped with a voltage-free contact
  • Broadcasting to the SIGFOX nationwide network

  • DIN rail (width 3U), IP20
  • powered from the mains, backup 1h by supercap or extended to 24h*
  • Input for electronical seal*
  • Manipulation detection (accelerometer)
  • Linkable to repeater SENSECOM-WSH to for hard-to-reach SIGFOX places (metal cabinets, shafts, basement, etc.)

* optional models

Impulse reading communication device

SENSECOM-IMD Datasheet EN

SENSECOM-IM1

  • Voltage-free impulse input
    • reading from water or gas meters or other devices equipped with a voltage-free contact)
  • Broadcasting to the SIGFOX nationwide network
  • Endurance > 5 years without battery replacement (1-2 messages per day)
  • IP20

SENSECOM-IM2

  • S0 impulse input
    • reading from secondary electricity meters and other devices with S0 output.
    • Optocoupler input separation (not powered) 
    • Distinguishes 2 tarrifs (via relay contact)
  • Broadcasting to the SIGFOX nationwide network
  • Endurance > 5 years without battery replacement (1-2 messages per day)
  • Connectable flood sensor
  • IP20