IoT Applications with Impulse reading
- Power, water, gas, heat or similar remote consumption readings with impulse output.
- Analysis of consumption savings and dynamic advance billing.
- Detection of media leakage or sharp consumption change (water, gas leakage).
- Irregular (volume based), daily or more frequent readings (15min-24h intervals)
- Monitoring of load or overload of machines or equipment (with detection of short-term peaks)
SENSECOM-IMD (IMDS, IMDBS), IMN
IoT communication unit key features:
- Remote consumption reading of electricity, water, gas, etc. using impulse sensor
- Primary input – S0 impulse input
- impulse reading from power-meter (billing or secondary) or other meter having S0 impulse input
- S0 – galvanically separated 4,5kV (separately powered optron)
- Supports 2-level tariffs (differentiation by grounding to neutral wire)
- Secondary voltage-free impulse input
- reading from a gas meter / water meter equipped with a voltage-free contact (or open collector connection, max 0.5V at max 0.5mA at closed state)
- Broadcasting to the nationwide network:
- SIGFOX (models IMD)
- NB-IoT (models IMN)
- DIN rail (width 3U), IP20
- powered from the mains, backup 1h by supercap or extended to 24h*
- Input for electronical seal*
- Manipulation detection (accelerometer)
- Linkable to repeater SENSECOM-WSH for hard-to-reach SIGFOX places (metal cabinets, shafts, basement, etc.) – aplicable for IMD models
* optional models
SENSECOM-IMT, IMHN
IoT communication unit key features:
- Remote consumption reading of electricity, water, gas, etc.
- Primary inputs:
-
- CNT0, CNT1 – voltage-free* impulse reading input from meters
- CNT0 input can separate impulses into 2 counters based on media flow direction using DIR input
- DIR – voltage-free* input applied for media flow direction resolution
- DI – voltage-free* digital input (no galvanic isolation), applied for eg. flood detection
- CNT0, CNT1 – voltage-free* impulse reading input from meters
*Alternatively, an open-collector output limited to max. 0.5 V at max. 0.5 mA in the closed state can be connected. There is no galvanic isolation of input.
- Broadcasting to the nationwide network IoT networks:
- SIGFOX (models IMT)
- NB-IoT (models IMHN)
- External ISM antenna via SMA connector
- powered from the lithium battery, size “C” (type SAFT LS 26500 3.6V, 7.7Ah)
- Linkable to repeater SENSECOM-WSH for hard-to-reach SIGFOX places (metal cabinets, shafts, basement, etc.) – aplicable for IMT models
- outdoor design, IP67
- Models:
- IMT – 1x M12 grommet
- IMT2 – 2x M12 grommet
